Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Observation:
Inspect the white connector for the installer access cover / wireless key.
It should be a firm fit, there should be a small gap from the red EMS BUS connector and it should be pushed fully home (as shown in the image).
If in doubt remove and refit the connector.
Is the connector fitment satisfactory?
It should be a firm fit, there should be a small gap from the red EMS BUS connector and it should be pushed fully home (as shown in the image).
If in doubt remove and refit the connector.
Is the connector fitment satisfactory?
Isolate as per TOPs P4
and refit as necessary