RESISTANCE RECTIFICATION LEAD (NO DISPLAY)

Set Appliance State:

Isolate Mains Power to appliance as per TOPs P4

Set Multimeter to Resistance

Gain access to PCB (use Insulation Mat as required)
NOT CURRENTLY USED
NOT CURRENTLY USED
NOT CURRENTLY USED
NOT CURRENTLY USED
Disconnect the lead from the flame sense electrode
(the front electrode of the three electrodes)

Measurement:

Measure the resistance between the disconnected lead and the green wire on X5 marked 11.1.
Short circuit (zero resistance) expected.
Short circuit measured
Open circuit measured

wc greenstar 36 cdi compact ige and thr safety close up.gif

wc greenstar 36 cdi compact j04485 pcb x5 connector.gif

After test don't forget Isolate as per TOPs P4 and refit as necessary