RESISTANCE PUMP AND HARNESS (ERP)

Set Appliance State:

Isolate Mains Power to appliance as per TOPs P4

Set Multimeter to Resistance

Remove connector CN2 from the PCB

Measurement:

Test 1.
Measure for resistance across pins 1 (blue) and 4 (brown) of CN2.
Expected resistance greater than 1Mohm (see note).
Test 2.
Measure for resistance across pin 4 (brown) and a suitable earth connection.
Expected resistance greater than 1Mohm.

Note.
Ensure a good connection is made or misdiagnosis will occur.
O.L displayed on the multimeter signifies a resistance greater than 1 Mohm.

Harness may differ in appearance but test points remain the same