RESISTANCE PRIMARY SENSOR AT PCB (FAULT CODE)

Set Appliance State:

Set Multimeter to Resistance

Isolate Mains Power to appliance as per TOPs P4
Disconnect plug connector (marked ST16) from PCB

Measurement:

Check resistance across connections 12 & 13 (red wires).
The resistance depends on temperature and should conform approximately to the table below:

Temperature °C	Resistance in kOhms
10	19.9
20	12.5
30	8.1
40	5.3
50	3.6
60	2.5
70	1.8
80	1.3

wc 28 cdi fca pcb connections exposed.gif

Note:
Care should be taken that probe tips do not touch each other when taking measurement as a false reading will be given. Also ensure that other end of leads are connected to the primary sensor.