PARAMETERS GUIDE

1. To access the parameters menu press and hold
the "reset" button for 10 seconds until "t5" starts to
flash in the display.
3. Using the bottom pair of + / - buttons on the facia
allows different parameters to be selected "P01 - P29"
Using the top pair of + / - buttons the value of the
flashing parameter can be changed.
At any time using the bottom pair of + / - buttons will
allow you to move to the next parameter saving the value
previously input.

2. Press the reset button once and "P01" will start to flash in the display.

4. Parameters that need to be checked
P01 This is the low water protection setting, this appliance has a low pressure sensor, set this to "1".
P02 This is the type of appliance parameter, set this to "1"
P04 This is the ignition fan speed, set this to "40"

5. When finished press and hold the "reset" button again for 10 seconds to save settings.

For more parameters please refer to the "Other" section in adapt. Parameters can be adjusted even if the boiler is displaying a fault code.