CASE REMOVAL - TWO PCB VERSION

Set Appliance State:

Isolate Mains Power to appliance as per TOPs P4

Measurement:

Front Panel:
Remove 3 screws from top of front panel and slide front panel off.

Side Panels:
Loosen screws from bottom and slide away at bottom slightly and lift to free from top lug and remove.

Note: This model is only for appliances with TWO PCBs. If appliance does not have a separate main PCB and ignition PCB do not use this XSol model as misdiagnosis will occur.

Fascia & Casing may differ in appearance but appliance operates the same