Adjust, Service, Repair or Replace as necessary
Isolate Water and Gas as appropriate
Location:
The C36 combination boiler is factory set for combustion and should need no adjustment. However in the event adjustment is required, check combustion errors are not a result of incorrectly installed flue and/or air system, terminal location or damage or debris on the burner. If all these factors are found to be in order refer to manufacturers instructions for adjustment procedure.
| Isolate Mains Power to appliance as per TOPs P4 |
Location:
Upon completion of the fault diagnostics carry out final electrical safety tests and checks as per TOPs (C6).
Refer to ADAPT for further information.
Please leave Feedback about this diagnosis via:
XSOL FEEDBACK FORM
Phone - 722429
or Email - Diaglab@britishgas.co.uk
