INSPECTION ELECTRODE

Set Appliance State:

Isolate Mains Power to appliance as per TOPs P4

Set Multimeter to Resistance

Remove electrode assembly from boiler

Measurement:

Thoroughly check the spark electrode for wear, contamination, cracks and damage, confirm electrode gap is 4mm +0.5mm.
Confirm continuity of electrode(see note 1.)
Expected resistance continuity (zero resistance).

vm vitodens 100-w bpa 29 kw combi 724981 ige .gif

vm vitodens 100-w bpa 29 kw combi inner upper.jpg

4mm + 0.5mm

Note.
1. if required clean the electrode with a small brush (not with a wire brush) or emery paper.
2. Refer to adapt regarding any gasket replacement requirements.