Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Set Multimeter to Resistance 
Remove connector CN1 from the interface PCB
Measurement:
Measure the resistance between the pins on CN1 and the terminals on the incoming mains terminal block as listed in the table below:
The Voltages should conform to the table below:
Expect continuity on each test.
Also visually inspect the harness for general condition and any signs of damaged insulation.
The Voltages should conform to the table below:
| Connector CN1 | Incoming terminal strip | Pin 4 (White) | Terminal 1 |
| Pin 5 (Yellow) | Terminal 3 |
| Pin 6 (Black) | Terminal 2 |
Expect continuity on each test.
Also visually inspect the harness for general condition and any signs of damaged insulation.
.gif)
Isolate as per TOPs P4
and refit as necessary