Set Appliance State:
CH Demand
DHW Demand
DHW Temperature Control on MAX
CH Temperature Control on MAX
Run DHW tap and allow at a flow rate of 8l/min to run for 10mins
Then run CH and allow to run until boiler temperature is satisfied
NOTE:System will reach temperature quicker if you reduce the load by turning off some radiators
CH Temperature Control on MAX
Run DHW tap and allow at a flow rate of 8l/min to run for 10mins
Then run CH and allow to run until boiler temperature is satisfied
NOTE:System will reach temperature quicker if you reduce the load by turning off some radiators
| WARNING! Mains voltage is expected during test, follow TOPs P4 live testing procedure |
Observation:
Does boiler run up to and at its maximum operating temperature without overheating again?
