Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Remove Gas Manifold Assembly
Observation:
Inspect the gap between the burner and the flame sense electrode.
The gap should be approximately 6mm.
Note:
1. Before reassembly check the integrity of all disturbed gaskets and seals and replace as necessary.
2. Upon reassembly all disturbed joints should
be checked for gas tightness.
The gap should be approximately 6mm.
Note:
1. Before reassembly check the integrity of all disturbed gaskets and seals and replace as necessary.
2. Upon reassembly all disturbed joints should
be checked for gas tightness.
Isolate as per TOPs P4
and refit as necessary