Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Unclip and remove the diverter motor
(this does not need appliance to be drained down)
(this does not need appliance to be drained down)
Observation:
Check that there is no signs of moisture or corrosion near the spindle.
Push the spindle in, a little more than finger pressure may be required.
Spindle should move in approx. 1cm then spring back to position immediately.
Note:
If moisture is present it is advisable
to check the diverter motor.
Push the spindle in, a little more than finger pressure may be required.
Spindle should move in approx. 1cm then spring back to position immediately.
Note:
If moisture is present it is advisable
to check the diverter motor.
Isolate as per TOPs P4
and refit as necessary