Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Disconnect plug from water pressure switch
Disconnect connector X7 from the PCB
Disconnect connector X7 from the PCB
Measurement:
Check that the connectors are in good condition.
Inspect the harness for good overall condition and that the harness is not in a position where it may get trapped and allow a wire to short to the case.
Inspect the harness for good overall condition and that the harness is not in a position where it may get trapped and allow a wire to short to the case.
Isolate as per TOPs P4
and refit as necessary