Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Remove the programmer from the facia of the appliance
Remove the connector from the PCB
Remove the connector from the PCB
| WARNING! - Mains voltage is expected during test follow TOPs P4 live testing procedure |
Observation:
If required reset appliance (press and hold reset button for 5 seconds, then release).
Turn ECO mode OFF (press and hold the ECO button until it is no longer illuminated).
This turns the pre heat function ON.
Does the pump now run with a preheat demand?
Note:
If pump still does not run leave programmer disconnected until diagnosis is complete.
Turn ECO mode OFF (press and hold the ECO button until it is no longer illuminated).
This turns the pre heat function ON.
Does the pump now run with a preheat demand?
Note:
If pump still does not run leave programmer disconnected until diagnosis is complete.
Isolate as per TOPs P4
and refit as necessary