Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Disconnect the rectification lead (front lead of the three electrodes)
and the flame sense ground lead (below the safety sensor) and make safe
Ensure NO demands
and the flame sense ground lead (below the safety sensor) and make safe
Ensure NO demands
| WARNING! - Mains voltage is expected during test follow TOPs P4 live testing procedure |
Observation:
Reset appliance.
If the appliance begins its self check mode ensure it is set to ECO.
Does the appliance now reset and enter standby or does it still go to fault code?
If the appliance begins its self check mode ensure it is set to ECO.
Does the appliance now reset and enter standby or does it still go to fault code?
Isolate as per TOPs P4
and refit as necessary