INFORMATION SETUP PARAMETER LIST

outside model, not currently used.

Observation:

Para No. Parameter Description Default Value
2.1A* Maximum Power CH Range rate of CH, adjustment in kW , max 24kW 24kW
2.1C Pump head selection Pump map(load and modulation percentage) 0 = Variable speed 1 to 4 option pump maps 0
2.1E Pump energy saving mode 4 = mode ON 5 = mode OFF 4
2.1H Min pump speed (speed at max CH burner load) Parameter only visible when 2.1C is set to 0 10%
2.1J Max pump speed(speed at max burner load) Parameter only visible when 2.1C is set to 0 100%
2.2C Air purge mode This feature can be selected to purge the system and boiler of air, 0 = off 1 = auto, active approx 100secs 0
2.3B Anti cycle time for CH Amount of time between stop and starts of the main heat ex for CH, between 0 and 60 min 10 min
2.3C Anti fast cycle temperature hysteresis Sets temperature drop before the burner restarts, in addition to "anti fast cycle time" between 2 to 15°K 6°K
Note:
1°K=1°C

Para No. Parameter Description Default Value
2.3F CH delay after DHW demand Time before boiler will heat CH after a DHW demand, set between 0 and 30mins 2 min
2.5F Service reminder time Set from 0-72months, displays H13 when due 0 (disabled)
2.7A Operation/fault indicator (blue light) activation 0 = blue light will only illuminate when fault occurs 1 = blue light will also illuminate when boiler is operating 1
2.9E Turbine signal delay Delay time before reacting to DHW demand, set in ¼ secs (min 0.5 secs=2,max 3 secs=12) 3
2.9F Pump overrun for CH Can be set between 3 and 30 minutes, actual time will be affected by Pump Energy Saving mode 3
3.1A* Max heating output Max output in kW 24kW
3.2B Maximum flow temperature This sets max temp for CH control knob, max 82°C 82°C
3.3D Min boiler power for CH and DHW Sets minimum output for appliance 6.8kW
*Appliance will run at whichever of these 2 values is lowest.

No navigation options available

Para No.	Parameter	Description	Default Value
2.1A*	Maximum Power CH	Range rate of CH, adjustment in kW , max 24kW	24kW
2.1C	Pump head selection	Pump map(load and modulation percentage) 0 = Variable speed 1 to 4 option pump maps	0
2.1E	Pump energy saving mode	4 = mode ON 5 = mode OFF	4
2.1H	Min pump speed (speed at max CH burner load)	Parameter only visible when 2.1C is set to 0	10%
2.1J	Max pump speed(speed at max burner load)	Parameter only visible when 2.1C is set to 0	100%
2.2C	Air purge mode	This feature can be selected to purge the system and boiler of air, 0 = off 1 = auto, active approx 100secs	0
2.3B	Anti cycle time for CH	Amount of time between stop and starts of the main heat ex for CH, between 0 and 60 min	10 min
2.3C	Anti fast cycle temperature hysteresis	Sets temperature drop before the burner restarts, in addition to "anti fast cycle time" between 2 to 15°K	6°K Note: 1°K=1°C