Set Appliance State:
Gas On
| WARNING! - Mains voltage is expected during test follow TOPs P4 live testing procedure |
Observation:
This fault situation can often be remedied by performing a hard reset of the PCB.
Please perform the following steps before continuing:
Reset appliance by holding reset button in for 5 seconds then releasing
Activate Service Mode (Chimney Sweep) FOR INFORMATION ON ACTIVATING SERVICE MODE CLICK HERE
Allow appliance to run for 30 seconds
Deactivate Service Mode (Chimney Sweep)
Perform the above steps twice more so the boiler has been put into and taken out of service mode 3 times in total.
Please select from one of the options below:
BOILER RESETS
BOILER WILL NOT RESET AND REMAINS ON F0 FAULT CODE
Please perform the following steps before continuing:
Reset appliance by holding reset button in for 5 seconds then releasing
Activate Service Mode (Chimney Sweep) FOR INFORMATION ON ACTIVATING SERVICE MODE CLICK HERE
Allow appliance to run for 30 seconds
Deactivate Service Mode (Chimney Sweep)
Perform the above steps twice more so the boiler has been put into and taken out of service mode 3 times in total.
Please select from one of the options below:
BOILER RESETS
BOILER WILL NOT RESET AND REMAINS ON F0 FAULT CODE