CASE REMOVAL

Set Appliance State:

Isolate Mains Power to appliance as per TOPs P4

Measurement:

To remove the front cover from the Ideal Logic Combi:
1. Locate and remove the two screws at the bottom of the boiler.
2. Disengage the two spring clips at the lower corners of the front case.
3. Pull the front case slightly forward from the bottom and lift to unhook from the top.
NOTE:
For correct use of this diagnostic model the Pre-heat function needs to be disabled by turning the Pre-heat selector switch to the OFF position. If the preheat button is blanked out then appliance does not have a pre-heat function.

This XSOL model is for use with appliances that have a serial number from ZH up to ANN & ANN, if it is used for other serial number versions then misdiagnosis will occur.
Do NOT use this model if you are working on the Logic Combi ErP version.