Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Set Multimeter to Resistance 
Gain access to control PCB
Measurement:
Measure the resistance across the center and left pins of the Hot Water potentiometer (located on the display PCB).
The resistances measured will alter as potentiometer is turned and should conform (approximately) with the readings below.
Note:
Ensure a good connection is made.
The resistances measured will alter as potentiometer is turned and should conform (approximately) with the readings below.
| Setting | |
| Minimum | |
| Medium | |
| Maximum |
Note:
Ensure a good connection is made.
