Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Turn Hot Water Tap On
Attach pressure gauge to gas valve pressure outlet test point
| WARNING! - Mains voltage is expected during test follow TOPs P4 live testing procedure |
Observation:
During the sparking stage of the ignition sequence
does the U-gauge show a pressure of at least the
minimum burner pressure for the appliance? (see table)
Notes:
1. When pressure gauge is removed the pressure test point
should be tightened and checked for gas tightness.
2. Ignition pressure should be approximately 6mb and is set via options on the PCB, however the burner should ignite and establish as long as the pressure is above minimum. Refer to ADAPT for more information.
does the U-gauge show a pressure of at least the
minimum burner pressure for the appliance? (see table)
Notes:
1. When pressure gauge is removed the pressure test point
should be tightened and checked for gas tightness.
2. Ignition pressure should be approximately 6mb and is set via options on the PCB, however the burner should ignite and establish as long as the pressure is above minimum. Refer to ADAPT for more information.
Isolate as per TOPs P4
and refit as necessary