Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Gain access to PCB (use Insulation Mat as required)
Observation:
The fault code displayed is not usually shown on this type of PCB.
Please visually confirm the appliance has two PCB's inside the housing.
If you are working on the one PCB version then click the link below to return to Adapt where you can reopen XSol and select the single PCB model.
Please visually confirm the appliance has two PCB's inside the housing.
If you are working on the one PCB version then click the link below to return to Adapt where you can reopen XSol and select the single PCB model.
