Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Gain access to PCB (use Insulation Mat as required)
Observation:
Move the jumper near the three LEDs from position 2&3
(Single LED mode) to position 3&4 (Triple LED mode), this
will enable full diagnostics via fault codes.
When mains power is switched on all three LEDs should flash for a few seconds, this can be used to confirm triple LED mode has been enabled.
Remember to set it back to single LED mode when diagnosis is complete.
(Single LED mode) to position 3&4 (Triple LED mode), this
will enable full diagnostics via fault codes.
When mains power is switched on all three LEDs should flash for a few seconds, this can be used to confirm triple LED mode has been enabled.
Remember to set it back to single LED mode when diagnosis is complete.
