Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Attach U-gauge to burner pressure test point
Disconnect blue wires from gas valve modureg
Set service potentiometer to MIN
Disconnect blue wires from gas valve modureg
Set service potentiometer to MIN
Gas On
| WARNING! Mains voltage is expected during test, follow TOPs P4 live testing procedure |
Observation:
Allow burner to ignite and establish.
Is the burner pressure now at approximately
minimum rate? (refer to table)
Note:
When pressure gauge is removed the pressure test point should be tightened and checked for gas tightness.
Is the burner pressure now at approximately
minimum rate? (refer to table)
Note:
When pressure gauge is removed the pressure test point should be tightened and checked for gas tightness.
Isolate as per TOPs P4
and refit as necessary