INITIAL SETUP INFORMATION PAGE

Observation:

APPLIANCE INITIAL SETUP
Unless stated otherwise in "Set appliance state" the following control settings are required to use this diagnostic model.
Note:
The green LED will flash accompanied by an audible signal to indicate that the key has been pressed.

The winter mode icon must be in the display, press the RESET button until this symbol appears.
(Do NOT press and hold reset for an excessive time)

Set DHW temperature to MAX 60°C, press the tap symbol then press the + key to increase the temperature. Once the temperature is adjusted press the tap symbol to exit.

Set CH temperature to MAX 80°C, press the radiator symbol then press the + key to increase the temperature. Once the temperature is adjusted press the radiator symbol to exit.

Note: Wiring harness colours may change but test points will remain the same.