Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Set Multimeter to Resistance 
Remove diverter valve motor
Remove electrical connector from the diverter motor
Remove electrical connector from the diverter motor
Measurement:
Measure the resistance between the terminals on the
diverter motor, it should conform approximately to the table below:
Note:
If you wish to remove the motor for ease of testing, it can
be removed without draining the appliance.
diverter motor, it should conform approximately to the table below:
| Pins | Resistance | 1-2 | 8.5 kOhms or greater |
| 2-3 | 8.5 kOhms or greater |
Note:
If you wish to remove the motor for ease of testing, it can
be removed without draining the appliance.
Isolate as per TOPs P4
and refit as necessary