Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Set Multimeter to Resistance 
Remove connector X3 from the PCB
Remove the plug from the pump assembly
Remove the plug from the pump assembly
Measurement:
Measure the resistance of each of the wires in the harness.
Expect continuity / zero resistance on each test.
Also visually inspect the condition of the wiring and connectors.
Note:
Pump plug may differ in appearance
but test remains the same.
Expect continuity / zero resistance on each test.
Also visually inspect the condition of the wiring and connectors.
Note:
Pump plug may differ in appearance
but test remains the same.
Isolate as per TOPs P4
and refit as necessary