Set Appliance State:
Mains Power Off
NO demands
| WARNING! - Mains voltage is expected during test follow TOPs P4 live testing procedure |
Observation:
Reset the appliance if required (Press reset button once then release)
If 'OFF' is on the display, then press the power button once briefly.
When the power is switched on the appliance should carry out a self-check and enter standby, this will take approximately 30 seconds to complete.
If the appliance has successfully entered standby mode then the only symbols on the display should be the tap and radiator.
If an error code is shown or the display does not operate, then choose that option below.
Note.
Some error codes will only occur with a demand
If 'OFF' is on the display, then press the power button once briefly.
When the power is switched on the appliance should carry out a self-check and enter standby, this will take approximately 30 seconds to complete.
If the appliance has successfully entered standby mode then the only symbols on the display should be the tap and radiator.
If an error code is shown or the display does not operate, then choose that option below.
Note.
Some error codes will only occur with a demand
