RESISTANCE HARNESS DIVERTER MOTOR

Set Appliance State:

Isolate Mains Power to appliance as per TOPs P4

Set Multimeter to Resistance

Remove connector CN9 from the PCB
Disconnect the electrical connector from the diverter motor

Measurement:

Measure the resistance between each of the pins on CN9
and the diverter motor connector as listed below:

Connector CN9	Diverter Motor Connector
Brown	Pin 3
Blue	Pin 2
Black	Pin 1

Expect continuity / zero resistance on each test.
Also visually inspect the condition of the harness.

Note.
On some PCB's the connector will be labelled as CN08 not CN9 and its orientation will differ, however the test points and expected results remain the same.