Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Observation:
Confirm PCB dip switches are set correctly.
Dip switch settings for Microgenus HE see table below.
Note:
1. Switch 1 jumper is factory set in position B
2. Switch 2 Anti-cycling adjustment for heating position A = 0 mins, position B = 2 mins.
3. Switch 3 under floor heating, position A = 38 - 44°C, position B = 42 - 82°C
4. Switch 4 jumper is factory set in position B
5. Switch 5 fan over-run (after DHW demand) position A = OFF, position B = ON
6. Switch 6 Tank equipped position A = Tank, position B = System
Dip switch settings for Microgenus HE see table below.
Note:
1. Switch 1 jumper is factory set in position B
2. Switch 2 Anti-cycling adjustment for heating position A = 0 mins, position B = 2 mins.
3. Switch 3 under floor heating, position A = 38 - 44°C, position B = 42 - 82°C
4. Switch 4 jumper is factory set in position B
5. Switch 5 fan over-run (after DHW demand) position A = OFF, position B = ON
6. Switch 6 Tank equipped position A = Tank, position B = System
