Measurement:
CASE REMOVAL
Remove 2X screws at the base of outer case.
Once the two screws have been removed, pull the outer case forward, then up to remove.
Note. The ignition PCB is located on the left-hand side of the board.
CASE REMOVAL
CASE REMOVAL
Remove 2X screws at the base of outer case.
Once the two screws have been removed, pull the outer case forward, then up to remove.
Note. The ignition PCB is located on the left-hand side of the board.
ONLY USE THIS XSOL MODEL FOR THE LATER VERSION OF PCB, SEPARATE IGNITION PCB (see note)
| Isolate Mains Power to appliance as per TOP's P4 |
Fascia may differ in appearance but boiler operates the same