Set Appliance State:
Turn Hot Water Tap On
Remove air inlet test point
Gas On
| WARNING! - Mains voltage is expected during test follow TOPs P4 live testing procedure |
Observation:
Activate the chimney sweep mode, set appliance to MAX rate.
Click here for guidance or refer to ADAPT.
Carry out a flue integrity test.
For the specific O2/CO2 readings permitted
for this appliance refer to ADAPT.
Note.
Once test is complete, refit the air inlet test point and test its integrity.
Click here for guidance or refer to ADAPT.
Carry out a flue integrity test.
For the specific O2/CO2 readings permitted
for this appliance refer to ADAPT.
Note.
Once test is complete, refit the air inlet test point and test its integrity.
Isolate as per TOPs P4
and refit as necessary