Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Set Multimeter to Resistance 
Disconnect X1 from the PCB
Disconnect plug from spark generator
(Push away from spark generator not downwards, easier if spark generator is removed from appliance)
Disconnect plug from spark generator
(Push away from spark generator not downwards, easier if spark generator is removed from appliance)
Measurement:
Check for continuity (zero resistance) on
each of the three wires running from
the spark generator to X1 at the PCB.
Inspect the harness and plugs for damage
and good overall condition.
each of the three wires running from
the spark generator to X1 at the PCB.
Inspect the harness and plugs for damage
and good overall condition.
Isolate as per TOPs P4
and refit as necessary