Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Set Multimeter to Resistance 
Remove Connector X13 from the PCB
Remove diverter valve head from body
Remove diverter valve head from body
Measurement:
Test 1:
Measure the resistance between pin 1 and pin 3 of connector X13.
Test 2:
Measure the resistance between pin 2 and pin 3 of connector X13.
Resistances should be either approx. 6.0 kOhms or
greater than 1M Ohm depending on the motor position.
Measure the resistance between pin 1 and pin 3 of connector X13.
Test 2:
Measure the resistance between pin 2 and pin 3 of connector X13.
Resistances should be either approx. 6.0 kOhms or
greater than 1M Ohm depending on the motor position.
Isolate as per TOPs P4
and refit as necessary