Set Appliance State:
Turn Hot Water Tap On
Gas On
| WARNING! - Mains voltage is expected during test follow TOPs P4 live testing procedure |
Observation:
Allow the boiler to run in DHW mode for a few minutes.
Test 1:
Measure the temperature of the DHW draw off pipe underneath the boiler (second pipe in from the left).
Note the reading.
Test 2:
Measure the temperature of the DHW at a hot water tap.
Are the two temperatures measured approximately the same or is there a large discrepancy?
Test 1:
Measure the temperature of the DHW draw off pipe underneath the boiler (second pipe in from the left).
Note the reading.
Test 2:
Measure the temperature of the DHW at a hot water tap.
Are the two temperatures measured approximately the same or is there a large discrepancy?
