Set Appliance State:
Mains Power Off
DHW Demand
DHW Selector in Maximum (+) position
CH Selector in Minimum (-) position
ON/OFF Switch in ON position
DHW Selector in Maximum (+) position
CH Selector in Minimum (-) position
ON/OFF Switch in ON position
Gas On
| WARNING! - Mains voltage is expected during test follow TOPs P4 live testing procedure |
Observation:
Test 1:
Reset lockout as necessary.
Does the burner ignite and establish? i.e. Re-ignition does NOT occur.
(If burner ignites and establishes correctly proceed to Test 2)
Test 2:
Allow burner to run for a few seconds once established then turn hot water tap off and monitor display.
Does burner extinguish without an F61 or F62 fault code?
Reset lockout as necessary.
Does the burner ignite and establish? i.e. Re-ignition does NOT occur.
(If burner ignites and establishes correctly proceed to Test 2)
Test 2:
Allow burner to run for a few seconds once established then turn hot water tap off and monitor display.
Does burner extinguish without an F61 or F62 fault code?
