Set Appliance State:
Mains Power Off
Set Multimeter to DC Volts 
CH Demand
DHW Selector in Minimum (-) position
CH Selector in Maximum (+) position
ON/OFF Switch in ON position
DHW Selector in Minimum (-) position
CH Selector in Maximum (+) position
ON/OFF Switch in ON position
Use Insulation Mat as required
| WARNING! - Mains voltage is expected during test follow TOPs P4 live testing procedure |
Measurement:
Measure voltage across terminal marked 9 and the terminal marked N on the controls installer interface.
Approximately 24 volts DC expected
Approximately 24 volts DC expected
Isolate as per TOPs P4
and refit as necessary