Set Appliance State:
Ensure NO demands
| WARNING! - Mains voltage is expected during test follow TOPs P4 live testing procedure |
Observation:
Reset the appliance (press and hold the reset button for 4 seconds then release)
The appliance will then start a 1.5 minute self-check program during which the pump should run for approximately 20 seconds.
While the self-check completes set the appliance CH thermostat to maximum.
(A DHW tap symbol may or may not be shown in the display this is not relevant to the model)
Monitor the appliance for the full 1.5 minutes before selecting an outcome.
If a fault code is shown at the end of the 1.5 minute self check click here.
The appliance will then start a 1.5 minute self-check program during which the pump should run for approximately 20 seconds.
While the self-check completes set the appliance CH thermostat to maximum.
(A DHW tap symbol may or may not be shown in the display this is not relevant to the model)
Monitor the appliance for the full 1.5 minutes before selecting an outcome.
If a fault code is shown at the end of the 1.5 minute self check click here.
 dis at standby.gif)