Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Set Multimeter to AC Volts 
For access behind the control panel
Release the fixing screw located at the top of the case front panel and lift the
panel upwards from its locating pins and then forwards from the boiler.
Remove the two fixing screws that secure the control panel and lower the panel.
For access to the control panel components
Remove the five screws securing the rear cover and careful raise the cover from
the control panel. When replacing the cover ensure no wires are trapped and all the
wiring is secured secure with screws previously removed do not over tighten.
Release the fixing screw located at the top of the case front panel and lift the
panel upwards from its locating pins and then forwards from the boiler.
Remove the two fixing screws that secure the control panel and lower the panel.
For access to the control panel components
Remove the five screws securing the rear cover and careful raise the cover from
the control panel. When replacing the cover ensure no wires are trapped and all the
wiring is secured secure with screws previously removed do not over tighten.
| WARNING! - Mains voltage is expected during test follow TOPs P4 live testing procedure |
Measurement:
Reset lock out as necessary.
Boiler switch to On.
All heating controls calling for heat.
Measure voltage across the terminals marked Ch.2 ON (white wire ) and the terminal marked N (blue wire).
Expected voltage mains voltage (230 volts AC).
Boiler switch to On.
All heating controls calling for heat.
Measure voltage across the terminals marked Ch.2 ON (white wire ) and the terminal marked N (blue wire).
Expected voltage mains voltage (230 volts AC).
Isolate as per TOPs P4
and refit as necessary