Set Appliance State:

Isolate Mains Power to appliance as per TOPs P4
Set Multimeter to Resistance Set meter to measure resistance
Remove the connector from the ignition control box

Measurement:

Test 1:
Measure the resistance between pin 8 and pin 9 on the ignition control box connector.
Expect approximately 40 - 60 Ohms.
Test 2:
Measure the resistance between pin 8 and pin 12 on the ignition control box connector.
Expect greater than 1 MOhm.
(O.L is acceptable because it is greater than 1MOhm)
Are the resistances as expected?