Set Appliance State:
Gas Off
| Isolate Mains Power to appliance as per TOPs P4 |
Remove air intake housing (twist and slide down)
Remove bearing plate
(located above the air intake)
Remove bearing plate
(located above the air intake)
Observation:
Inspect the condition of the fan bearing plate ensuring the rubber flaps are complete and not broken off.
Note:
1. Upon reassembly all disturbed joints should be checked
for gas tightness.
2. Before reassembly check the integrity of all disturbed gaskets
and seals and replace as necessary.
Note:
1. Upon reassembly all disturbed joints should be checked
for gas tightness.
2. Before reassembly check the integrity of all disturbed gaskets
and seals and replace as necessary.
Isolate as per TOPs P4
and refit as necessary