Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Remove wires from top two terminals of
connector X106 and make safe
Fit a wire link between top two terminals of
connector X106 as shown below
connector X106 and make safe
Fit a wire link between top two terminals of
connector X106 as shown below
| WARNING! - Mains voltage is expected during test follow TOPs P4 live testing procedure |
Observation:
Reset appliance.
(Press and hold the power button for 4 seconds then release)
Has the fault code now cleared?
Note:
If fault code clears with link fitted DO NOT leave link in place rectify issue with underfloor heating controls.
(Press and hold the power button for 4 seconds then release)
Has the fault code now cleared?
Note:
If fault code clears with link fitted DO NOT leave link in place rectify issue with underfloor heating controls.
Isolate as per TOPs P4
and refit as necessary