Set Appliance State:
| Isolate Mains Power to appliance as per TOPs P4 |
Gain access to PCB (use Insulation Mat as required)
Remove the sensor by pulling down at the front and pushing gently back
Remove the sensor by pulling down at the front and pushing gently back
Observation:
Check the two connections between Sensor and Gas Valve.
Note:
Both connections should have a sealing 'O' ring for correct operation.
Refit sensor.
Note:
Both connections should have a sealing 'O' ring for correct operation.
Refit sensor.
Isolate as per TOPs P4
and refit as necessary